Project Arcade 10 of 0.0

Lots of head way was made.

I got the base cut and put togeather and ran across a few issues.
1st some of the boards didnt fit 100% but we where able to get them knock in to place
2nd the main board in the front bent in over night while the glue dried and we didnt notice when we marked and drilled the holes for the screws :| so stuff is off but no biggy no one will notice but then ill allways know  :|

Every thing in place and letting the glue dry over night to get a nice good grip.


From this i should have made a support beam for the middle to keep stuff from bowing but oh well.



Had issues with removing the template off  due to it being on for so long and ended having to use laquer thinner to help peel it off the sticker but once i got that off i went ahead and stained a scrap peace of wood to see how it will turn out while that dryed i started to sand and get every this ready for the staining.

I had a bit of an issue with some of the pin markings bleeding through so I had to pick a darker stain to cover up the marks. :|